Four Mistakes To Avoid With Your Industrial Aluminium Cutting
Aluminium is a soft metal and can be easily damaged if you don't treat it properly. There are several mistakes that can be made when cutting aluminium, but some of them are more serious than others.
Here are four mistakes to avoid with your industrial aluminium cutting:
1. Industrial Aluminium Cutting Mistake Number One: Cutting Aluminium With A Hacksaw
A hacksaw is not the best tool for cutting industrial aluminium because it can easily get damaged. When you use this tool to cut the metal, it will bend and break the blade easily due to its hardness. A better tool for cutting industrial aluminium is an electric saw or a plasma cutter. These tools can cut through even thick sheets of aluminium with relative ease.
2. Industrial Aluminium Cutting Mistake Number Two: Cutting At The Wrong Angle
The angle at which you cut your material will directly affect how easy it is to machine and how cleanly it cuts, as well as how accurately you are able to cut out your part. If you cut at too steep an angle, then you risk damaging the blade or breaking off pieces of material inside, which will cause further problems down the line when trying to remove them from around your workpiece. If you cut at too shallow an angle, then it will take longer for the tool bit to penetrate through the material, and this can also result in poor quality cuts with chipping around edges
3. Industrial Aluminium Cutting Mistake Number Three: Not Using A Guide Block Or Fence
When cutting aluminium sheets, especially if they are large or thick sheets of aluminium, it's important to use something called a guide block or fence when performing your cut so that your board doesn't move around as you're trying to perform your cut. If there is no guide block or fence on your guillotine, then use something else as a temporary solution until you can get one made by someone who knows what they're doing in terms of industrial aluminium cutting machines.
4. Industrial Aluminium Cutting Mistake Number Four: Not Using The Right Lubricant
Lubricants are essential when cutting aluminium because otherwise, they will create friction, which causes heat build-up and warping of your material. Make sure that you use a pure mineral oil-based lubricant or other non-mineral oils to avoid leaving behind residues which cause more problems than benefits when working with aluminium.
Contact a professional for more information about aluminium cutting.